Got a leak?

If that old faucet just can’t be fixed and you saved the old handles then here is a project for you!  I kept these handles from an old claw foot tub and have had them for decades.  
I have been fussing with these faucet handles for some very long time and on Tuesday, it finally all came together.  I was wandering around Habitat for Humanity….looking for a bargain, and found some old ceiling tiles.  You know the kind….pressed sawdust with designs.  There were a couple pieces with a slight lace effect and so I grabbed them for .25ea.  Now mind you, I was looking for the tin kind for this project but they or even anything similar was not to be found.  So I settled on this, as it also gave me a good base to attach my handles.
Here’s a little photo display to explain what I did….
Using a matte knife and metal edge ruler, I cut the tile down to fit the frame.
  

At this point, I measured for the handles and used a sharp nail to punch holes for my screws.  Depending on what material you use for the background, you may need to predrill your holes.  In some cases I used nuts and bolts to hold the handles to the base.  It took me almost two hours to get the right screws, etc. with help, at the hardware store!  Old parts don’t have the new screw sizes!  Be prepared! 

I happened to have a ‘deep dish’ frame for this one so I have several stacks of cardboard to fill in. 

Excuse the ‘girlie’ hammer, I don’t personally use one this small but it was in the house and it is cold outside in the garage….thus, use what’s on hand!
 
Since I found two of those ‘H’ handles at Habitat for .50 ea. I decided to make two of these ‘pictures’.  The frames were each $1 and I spray painted them, had the paint and the handles….I am out…$1.75 for each framed ‘Art ‘. 

This one goes in my bathroom but must wait for another project to get finished before it gets hung.  It is another one with handles of a sort so it may take awhile, as well.

Check out this party...... coastalcharm.blogspot.com/